Let's make an original magnet ♪
Magnets that are useful in refrigerators, desks, lockers, etc. Keeping a TODO list or message memo will increase the chances of seeing it, so if you have a favorite design, you will feel a little better.
For those who collect design paper, scraps, stickers, etc., we recommend a remake that changes the mount of the clear magnet that you can buy for 100 yen. This time, I will introduce the method using magnets of 100-yen shops "Daiso" and "Ceria".
Daiso's clear magnet
Click here for those who seek beauty
Daiso's 6-piece magnet is a type in which glass and magnet are glued together. It can be easily disassembled by soaking it in hot water that is slightly hotter than the bath.
Soak in hot water for a while
The mount attached to the magnet can be removed by rubbing it with your nails, but a thin film of adhesive remains on the glass side. This is a spatula and should be rubbed off with a strong force. I used a plastic ruler, but avoid something too hard to avoid damaging the glass.
Because the adhesive film remains
Scrape off with a plastic ruler, etc.
At the end, rub the whole on the tissue to make it shiny!
Rub the finish on the tissue
If you process this carefully, the finish will be beautiful.
Next, prepare a piece of paper or cloth to put in the magnet and attach it to the magnet with a woodworking bond. Depending on the material, the magnet below can be seen through, so it is safe to stick white paper on the mount.
Stick white paper on the back of the mount and stick it on the magnet. This is a cut out paper bag from Daiso.
When it dries, it finally adheres to the glass. Apply a glass repair bond that becomes transparent when it dries to the mount, and firmly press it against the glass to remove air bubbles. The author used Konishi's epoxy resin bond "Quick 5".
"Bond Quick 5" that mixes two agents
If you dry it without moving it, it's done! It takes a little work, but the texture of the glass is still attractive.
The chubby texture is wonderful
The one on the right has no paper pasted on the back of the mount. The magnet has seen through.
Ceria neodymium magnet
Next is the method of using the "neodymium magnet" sold in Ceria. Although it is a small grain, it is a powerful magnet that can hold 5 sheets of copy paper.
This is just covered with a plastic cover, so you can easily remove it from the back with a cutter. Insert the cutting edge into the groove and open the lid of the milk bottle.
Can be easily removed with the cutting edge of a cutter
Disassembled into cover, mount, and magnet
Take out the paper inside, insert a mount of the same size, close it again, and you're done. It's difficult to choose a pattern because it's small, but it's very easy, so it might be a good idea to start from now on.
Even if you put masking tape on the original mount
A magnet remake with a moderate degree of difficulty that makes you crazy when you create it. How about playing at home during the rainy season?